Aruba серии 103

Гарантия:1 год
Документация:
Описание
Наличие:По запросу

OPERATING MODES
802.11a/b/g/n Aruba Instant AP 802.11a/b/g/n Mobility Controller-managed AP Air monitor (AM) for wireless IDS, rogue detection and containment Spectrum analyzer Secure enterprise mesh Remote AP (RAP) when used with a Mobility Controller

OPERATING MODES

802.11a/b/g/n Aruba Instant AP
802.11a/b/g/n Mobility Controller-managed AP
Air monitor (AM) for wireless IDS, rogue detection and containment
Spectrum analyzer
Secure enterprise mesh
Remote AP (RAP) when used with a Mobility Controller

WIRELESS RADIO SPECIFICATIONS
AP type: Indoor, dual radio, 5-GHz and 2.4-GHz 802.11n 2x2:2 Software-configurable dual radio supports 5-GHz (Radio 0) and 2.4-GHz (Radio 1) 2x2 MIMO with two spatial streams and up to 300 Mbps wireless data rate Supported frequency bands (country-specific restrictions apply): 2.4000 to 2.4835 GHz 5.150 to 5.250 GHz 5.250 to 5.350 GHz 5.470 to 5.725 GHz 5.725 to 5.850 GHz Support for up to 255 associated client devices per radio, and up to 16 BSSIDs per radio Available channels: Dependent on configured regulatory domain Dynamic frequency selection (DFS) optimizes the use of available RF spectrum Supported radio technologies: 802.11b: Direct-sequence spread-spectrum (DSSS) 802.11a/g/n: Orthogonal frequency-division multiplexing (OFDM) Supported modulation types: 802.11b: BPSK, QPSK, CCK 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM Transmit power: Configurable in increments of 0.5 dBm Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements): 2.4-GHz band: +21 dBm (18 dBm per chain) 5-GHz band: +21 dBm (18 dBm per chain) Advanced Cellular Coexistence (ACC) minimizes interference from LTE cellular networks Maximum ratio combining (MRC) for improved receiver performance Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance Short guard interval for 20-MHz and 40-MHz channels Space-time block coding (STBC) for increased range and improved reception Low-density parity check (LDPC) for high-efficiency error correction and increased throughput Supported data rates (Mbps): 802.11b: 1, 2, 5.5, 11 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54 802.11n: 6.5 to 300 (MCS0 to MCS15) 802.11n high-throughput (HT) support: HT 20/40 802.11n packet aggregation: A-MPDU, A-MSDU

WIRELESS RADIO SPECIFICATIONS

AP type: Indoor, dual radio, 5-GHz and 2.4-GHz 802.11n 2x2:2
Software-configurable dual radio supports 5-GHz (Radio 0) and 2.4-GHz (Radio 1)
2x2 MIMO with two spatial streams and up to 300 Mbps wireless data rate
Supported frequency bands (country-specific restrictions apply):
- 2.4000 to 2.4835 GHz
- 5.150 to 5.250 GHz
- 5.250 to 5.350 GHz
- 5.470 to 5.725 GHz
- 5.725 to 5.850 GHz
Support for up to 255 associated client devices per radio, and up to 16 BSSIDs per radio
Available channels: Dependent on configured regulatory domain
Dynamic frequency selection (DFS) optimizes the use of available RF spectrum
Supported radio technologies:
- 802.11b: Direct-sequence spread-spectrum (DSSS)
- 802.11a/g/n: Orthogonal frequency-division multiplexing (OFDM)
Supported modulation types:
- 802.11b: BPSK, QPSK, CCK
- 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM
Transmit power: Configurable in increments of 0.5 dBm
Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements):

2.4-GHz band: +21 dBm (18 dBm per chain)
5-GHz band: +21 dBm (18 dBm per chain)

Advanced Cellular Coexistence (ACC) minimizes interference from LTE cellular networks
Maximum ratio combining (MRC) for improved receiver performance
Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance
Short guard interval for 20-MHz and 40-MHz channels
Space-time block coding (STBC) for increased range and improved reception
Low-density parity check (LDPC) for high-efficiency error correction and increased throughput
Supported data rates (Mbps):
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: 6.5 to 300 (MCS0 to MCS15)
802.11n high-throughput (HT) support: HT 20/40
802.11n packet aggregation: A-MPDU, A-MSDU

POWER
Maximum power consumption: 9.5W (POE) or 8W (DC) Power sources sold separately Direct DC source: 12 Vdc nominal, +/- 5% Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af or 802.3at-compliant source

POWER

Maximum power consumption: 9.5W (POE) or 8W (DC)
Power sources sold separately
Direct DC source: 12 Vdc nominal, +/- 5%
Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af or 802.3at-compliant source

ANTENNAS
Two integrated dual-band downtilt omni-directional antennas for 2x2 MIMO with maximum antenna gain of 4.0 dBi in 2.4 GHz and 4.5 dBi in 5 GHz. Built-in antennas are optimized for horizontal ceiling mounted orientation of the AP. The downtilt angle for maximum gain is approximately 30 degrees.

ANTENNAS

Two integrated dual-band downtilt omni-directional antennas for 2x2 MIMO with maximum antenna gain of 4.0 dBi in 2.4 GHz and 4.5 dBi in 5 GHz. Built-in antennas are optimized for horizontal ceiling mounted orientation of the AP. The downtilt angle for maximum gain is approximately 30 degrees.

OTHER INTERFACES
10/100/1000BASE-T Ethernet network interface (RJ-45) Auto-sensing link speed and MDI/MDX 802.3az Energy Efficient Ethernet (EEE) PoE-PD: 48 Vdc 802.3af PoE or 802.3at PoE+ DC power interface, accepts 1.7/4.0-mm center-positive circular plug with 9.5-mm length Serial console interface (proprietary; optional adapter cable available) Visual indicators (LEDs): Power/system status Ethernet link status (ENET) Radio status (2x; RAD0, RAD1) Kensington security slot Reset button

OTHER INTERFACES

10/100/1000BASE-T Ethernet network interface (RJ-45)
- Auto-sensing link speed and MDI/MDX
- 802.3az Energy Efficient Ethernet (EEE)
- PoE-PD: 48 Vdc 802.3af PoE or 802.3at PoE+
DC power interface, accepts 1.7/4.0-mm center-positive circular plug with 9.5-mm length
Serial console interface (proprietary; optional adapter cable available)
Visual indicators (LEDs):
- Power/system status
- Ethernet link status (ENET)
- Radio status (2x; RAD0, RAD1)
Kensington security slot
Reset button

MOUNTING
Included with AP: Mounting brackets (2) for attaching to 9/16-inch or 15/16-inch T-bar drop-tile ceiling Spare mounting kit: AP-220-MNT-C1: Aruba AP mount kit contains two ceiling-grid rail adapters for flat rails Optional mounting kits: AP-220-MNT-C2: Aruba AP mount kit contains two ceiling-grid rail adapters for Interlude and Silhouette style rails AP-220-MNT-W1: Aruba AP mount kit contains one flat-surface wall/ceiling mount bracket AP-200-MNT-W2: Aruba AP mount kit contains one flat-surface wall/ceiling secure mount cradle

MOUNTING

Included with AP:
- Mounting brackets (2) for attaching to 9/16-inch or 15/16-inch T-bar drop-tile ceiling
Spare mounting kit:
- AP-220-MNT-C1: Aruba AP mount kit contains two ceiling-grid rail adapters for flat rails
Optional mounting kits:
- AP-220-MNT-C2: Aruba AP mount kit contains two ceiling-grid rail adapters for Interlude and Silhouette style rails
- AP-220-MNT-W1: Aruba AP mount kit contains one flat-surface wall/ceiling mount bracket
- AP-200-MNT-W2: Aruba AP mount kit contains one flat-surface wall/ceiling secure mount cradle

MECHANICAL
Dimensions/weight (unit, excluding mount accessories): 150 mm (W) x 150 mm (D) x 41.5 mm (H) 5.9” (W) x 5.9” (D) x 1.63” (H) 300 g (0.66 lbs) Dimensions/weight (shipping): 192 mm (W) x 178 mm (D) x 68 mm (H) 7.6” (W) x 7.0” (D) x 2.68” (H) 500 g (1.10 lbs)

MECHANICAL

Dimensions/weight (unit, excluding mount accessories):
- 150 mm (W) x 150 mm (D) x 41.5 mm (H)
- 5.9” (W) x 5.9” (D) x 1.63” (H)
- 300 g (0.66 lbs)
Dimensions/weight (shipping):
- 192 mm (W) x 178 mm (D) x 68 mm (H)
- 7.6” (W) x 7.0” (D) x 2.68” (H)
- 500 g (1.10 lbs)

ENVIRONMENTAL
Operating: Temperature: 0° C to +40° C (+32° F to +104° F) Humidity: 5% to 95% non-condensing Storage and transportation temperature range: Temperature: -40° C to +70° C (-40° F to +158° F)

ENVIRONMENTAL

Operating:
- Temperature: 0° C to +40° C (+32° F to +104° F)
- Humidity: 5% to 95% non-condensing
- Storage and transportation temperature range:
  - Temperature: -40° C to +70° C (-40° F to +158° F)

REGULATORY
FCC/Industry of Canada CE Marked R&TTE Directive 1995/5/EC Low Voltage Directive 72/23/EEC EN 300 328 EN 301 489 EN 301 893 UL/IEC/EN 60950 EN 60601-1-1 and EN 60601-1-2 For more country-specific regulatory information and approvals, please see your Aruba representative.

REGULATORY

FCC/Industry of Canada
CE Marked
R&TTE Directive 1995/5/EC
Low Voltage Directive 72/23/EEC
EN 300 328
EN 301 489
EN 301 893
UL/IEC/EN 60950
EN 60601-1-1 and EN 60601-1-2
For more country-specific regulatory information and approvals, please see your Aruba representative.

REGULATORY MODEL NUMBERS
AP-103 and IAP-103: APIN0103

REGULATORY MODEL NUMBERS

AP-103 and IAP-103: APIN0103

CERTIFICATIONS
CB Scheme Safety, cTUVus UL2043 plenum rating Wi-Fi Alliance (WFA) certified 802.11a/b/g/n

CERTIFICATIONS

CB Scheme Safety, cTUVus
UL2043 plenum rating
Wi-Fi Alliance (WFA) certified 802.11a/b/g/n

WARRANTY
Limited lifetime warranty

WARRANTY

Limited lifetime warranty

MINIMUM SOFTWARE VERSIONS
ArubaOS 6.4.0.0 Aruba InstantOS 4.1.0.0

MINIMUM SOFTWARE VERSIONS

ArubaOS 6.4.0.0
Aruba InstantOS 4.1.0.0

Aruba серии 103

Решения

Необходима консультация?

Aruba серии 103

Решения

Необходима консультация?

Запрос цены на продукт

Взять в демо

Попробовать бесплатно!